How Do I Hang Kitchen Cabinets

By popi 30 Mar, 2020 Post a Comment

Transfer stud locations from the wall to the inside of each cabinet before you lift it into place. Drill four holes through back of cabinet which correspond to the stud locations.

Image Result For Hanging Kitchen Cabinets Hanging Kitchen

Mark stud locations onto back of cabinet.

How do i hang kitchen cabinets. It s time to install the first wall cabinet. Set the first wall cabinet on the ledger strip and 1 4 inch away from its reference line on. Then drill and or saw out the openings.

Start by attaching a straight 1 by 4 ledger level on the wall at the 54 inch line. Set cabinet on cabinet jack hold cabinet level then fasten to wall studs with 2 inch drywall screws and finishing washers. Drill and countersink pilot holes hang the rest of the cabinets the way you hung the first ones checking for level and plumb as you go.

Draw a horizontal line at your mark. Measure up 19 1 2 in. At the shim locations counterbore and fasten cabinet to the floor with deck screws without washers.

Begin your installation with a corner cabinet or from the far left if you don t have a corner unit. Locate wall studs using hammer and finishing nail. Measure and make a mark 54 inches 137 cm from the floor.

Label the location of the kitchen wall cabinets and appliances on the wall. Mark cabinet layout lines onto the wall. Step 7 install remaining base cabinets.

Position the second cabinet on the ledger and next to the. Secure ledger board along the hanging line. Measure and mark the wall.

Remove all doors handles. Hang the wall cabinets. How to install kitchen cabinets step 5.

Finally mark the stud locations as you begin a how to install kitchen cabinets project. Once all the wall cabinets are in place remove the ledger screws or holding screws you installed in step 1. Draw a vertical line to line up the edge of the first cabinet to be installed.

With the cabinet seated against its shims drive 2 inch deck screws with washers through the cabinet back and into the studs. A ledger is a board that helps support the cabinetry as. Check that the top of the cabinet is level and add shims underneath as necessary.

Make plumbing and electrical cutouts. Find the wall studs using a stud finder. Lay out plumbing and electrical openings on the cabinet back using the layout lines on the wall as reference points.

Kitchen floor cabinets photo 7. How to install wall and base kitchen cabinets step 1. Using the outline you.

Trim any visible shims flush with the cabinet using a utility knife. Determine if your floor is level. How to hang wall cabinets steps plan your space.

From that line and draw another line for the bottom of the upper cabinets.

How To Install Cabinets Like A Pro Installing Kitchen Cabinets